W660 Charnwood Panel cutting table saw 3hp motor
Panel saw with 48' Sliding beam.
- 3hp Induction Motor
- Cast Iron table saw
- 4’ Travel Sliding Beam
- Rip Fence with Micro Adjuster
- All Extension Tables Included
- Mitre Fence Included
Based on our best selling 10” Table Saw, we have increased the specification by adding a more powerful motor and a sliding beam with a 1220mm length of cut. This makes the saw ideal for handling large panels, anything up to an 8’ x 4’ sheet. The sliding beam of this table saw, runs on a set of bearings along a sturdy support bed with additional support legs at each end. This gives a very smooth action with a high degree of accuracy. The beam can be locked in position when using the rip fence.
The extension table is also supported by a telescopic arm to take the weight of larger panels. The squaring arm at the rear of the table can be adjusted at any angle up to 45 degrees and is fitted with a flip over stop for repeat measurements.
For crosscutting smaller pieces we also provide a mitre fence which locks onto the sliding beam and can be adjusted to any angle from 90 to 45 degrees.
|Main Table Size ||650mm x 620mm |
|Maximum Ripping Width Using Fence ||610mm |
|Support Table Size ||450mm x 350mm |
|Maximum Crosscutting Width ||1225mm |
|Blade Tilt ||90 - 45 degrees |
|Cutting Depth at 90 degrees ||80mm |
|Cutting Depth at 45 degrees ||56mm |
|Blade Diameter ||250mm |
|Blade Bore ||30mm |
|Work Table Height ||830mm |
|Motor (induction) || 2200w (3hp) / 240v |
|No-load Blade Speed ||4000rpm |
|Dimensions (WxDxH) ||1330mm x 1500mm x 1130mm |
|Weight || 170Kg |
|Rating ||Trade |
|Warranty ||1 Year |
It is highly recommended that a dust extractor is used at all times with this saw to prevent the harmful build up of dust and chips. The hose kit supplied collects dust from the sawguard and takes it to the single 100mm diameter hose connection point at the side of the machine
- Extra carriage charges may apply to Scottish Highlands & Islands, please enquire.